13 53 310 Removing and installing/replacing an injector (N55)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Observe WARNINGS ON REMOVAL OF THE INJECTORS without fail!
IMPORTANT:
There are two different injector versions and hold-down device versions for the N55 engine.
A mixed installation of the components (hold-down device, spark plug shafts, injectors, cylinder heads and screws) between the two hold-down device versions is not possible/permitted!
Removal and installation of the various injectors are described separately according to the hold-down device version.
The hold-down device version must be identified beforehand in order to select the correct repair instructions.
Remove ACOUSTIC COVER
A mixed installation of the components (hold-down device, spark plug shafts, injectors, cylinder heads and screws) between the two hold-down device versions is not possible/permitted!
Removal and installation of the various injectors are described separately according to the hold-down device version.
The hold-down device version must be identified beforehand in order to select the correct repair instructions.
Remove ACOUSTIC COVER
The bottom hold-down device version can be found on the electromagnetic compatibility panel (1) installed above the injectors.
- Up to engine number 14407684: see REMOVING AND INSTALLING INJECTOR .
- Only E70, E71
:
Removing and installing injector up to engine number 02167648 .
The top hold-down device version can be found on the hold-down device installed on top (1).
- From engine number 14407685: see REMOVING AND INSTALLING INJECTOR .
- Only E70, E71
:
Removing and installing injector from engine number 02167649 .