65 50 125 Removing and installing/replacing left or right rear monitor

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Installation note:

Remove REAR PASSENGER COMPARTMENT MONITOR COVER .

Release screws (1).

Tightening torque 65 50 2AZ .

Remove rear passenger compartment monitor (2) from holder (3).

Installation note:

Make sure rear passenger compartment monitor (2) is correctly seated on holder (3).

Fig 1: Identifying Screws, Rear Passenger Compartment Monitor And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections and disconnect.

Remove monitor in rear (1).

Fig 2: Removing Plug Connections And Monitor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .