65 50 165 Removing and installing/replacing trim for rear monitor display at rear
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic damage (ESD protection).
Necessary preliminary work
Release screws (1).
Tightening torque 65 50 1AZ .
Remove cover (3) from rear monitor (4), unclipping plug (2) and feed out cable.
Installation note:
Make sure cover (3) is correctly seated on rear monitor (4).