72 11 096 Removing and installing/replacing rear left or right lower strap (belt buckle)

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove left REAR SEAT .

Installation:

Microencapsulated screws (Loctite) must be replaced and may not be reused
Screw connection must be completed within 20 minutes (start of curing)
Microencapsulated screws must not be retightened
Clean thread of nut beforehand in event of repeated use

Seat belt buckle, right:

Detach cover (1).

Release screw (2).

Tightening torque 52 26 08AZ .

Pull folding cover forward and lift up to remove.

Fig 1: Removing Folding Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Installation:

Replace screw (1).

Tightening torque, see 72 11 22AZ.

Remove seat belt buckle.

Installation:

Seat belt buckle is coded to prevent incorrect installation.

Fig 2: Identifying Seat Belt Buckle Mounting Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Seat belt buckle, left:

Release screw (1).

Installation:

Replace screw (1).

Tightening torque, see 72 11 22AZ.

Remove seat belt buckle.

Installation:

Seat belt buckle is coded to prevent incorrect installation.

Fig 3: Identifying Seat Belt Buckle Mounting Screw

Courtesy of BMW OF NORTH AMERICA, INC.