37 14 055 Removing and installing/replacing Vertical Dynamics Management control unit (VDM with Dynamic Drive)

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove ignition key.
Disconnect BATTERY NEGATIVE LEAD .
Remove SIDE TRIM PANEL FROM FOOTWELL ON RIGHT A-PILLAR .

Fold carpet in footwell at bottom right to one side.

Release screws (1).

Tightening torque 37 14 6AZ .

Fig 1: Identifying Vertical Dynamics Management Control Unit Footwell Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) in direction of arrow and disconnect.

Remove control unit.

Fig 2: Unlocking Vertical Dynamics Management Control Unit Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Replacement only: Carry out PROGRAMMING/ENCODING .