12 41 020 Removing and installing/replacing starter (N63)

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work

Switch off ignition.
Disconnect BATTERY EARTH LEAD. .
Remove right ENGINE SUPPORT ARM. .

Release connector (1) and remove.

Slacken nut (2).

Tightening torque 12 42 2AZ.

Detach starter positive cable.

Fig 1: Identifying Starter Connector And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 12 41 1AZ.

Disengage cable (2) from holder.

Pull out starter in direction of travel, feed out and remove.

Installation note:

When replacing the starter, convert cable holder for cable (2).

Fig 2: Identifying Starter Screws And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check starter pinion and starter ring gear for damage. If necessary, replace damaged components.

Reassemble the vehicle.