11 65 010 Removing and Installing/Replacing Pressure Accumulator (N63)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary Preliminary Tasks:

Remove Both Exhaust Turbochargers. See RIGHT TURBO (CYLINDERS 1-4) and LEFT TURBO (CYLINDERS 5-8) .
Remove Both Exhaust Manifolds. See LEFT EXHAUST MANIFOLD and RIGHT EXHAUST MANIFOLD .
Remove HEAT SHIELD At Bottom

Release Banjo Bolt (1).

Tightening torque 11 42 3AZ .

Installation Note:

Replace Sealing Ring.

Release Screw (3) On Engine Oil Line.

Remove Engine Oil Line (2).

Release Screws (3) On Vacuum Reservoir (4).

Tightening torque 11 65 6AZ .

Remove Vacuum Reservoir (4).

Fig 1: Identifying Vacuum Reservoir, Banjo Bolt and Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Check VACUUM CONNECTIONS for Correct Routing.

Check Vacuum System for LEAKS .

Assemble Engine.