72 11 096 Removing and installing/replacing rear left or right lower strap (belt buckle)
Necessary preliminary tasks:
- Remove left REAR SEAT
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Seat belt buckle, right:
Detach cover (1).
Release screw (2).
Tightening torque 52 26 08AZ .
Pull folding cover forward and lift up to remove.
Release screw (1).
Installation:
Replace screw (1).
Tightening torque 72 11 22AZ .
Remove seat belt buckle.
Installation:
Seat belt buckle is coded to prevent incorrect installation.
Seat belt buckle, left:
Release screw (1).
Installation:
Replace screw (1).
Tightening torque 72 11 22AZ .
Remove seat belt buckle.
Installation:
Seat belt buckle is coded to prevent incorrect installation.