51 43 002 Removing and installing rear left or right side trim panel
Special tools required:
Necessary preliminary tasks:
- Release SEAT BELT COVER
- Remove ARMREST SIDE SECTION
- Remove REAR SEAT
Detach edge protector (1) in area of side trim (2).
Carefully release side trim panel (2) from clamps (3) and clips (4) with special tool 00 9 317 starting at the front.
Unlock associated plug connections and disconnect.
Remove side trim panel (2).
Installation note:
If necessary, replace faulty clips (4) and clamps (3).
Installation note:
Side trim panel (1) must fit correctly in guides (2).
When replacing, swap over the following parts: