17 11 054 Removing and replacing right module carrier (N20, N52K, N54, N54T)
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of scalding!
Only perform this repair work after engine has cooled down.
Only perform this repair work after engine has cooled down.
WARNING:
Danger of injury!
Refrigerant circuit is under high pressure!
Follow safety information for handling refrigerant. See INSTRUCTIONS FOR HANDLING REFRIGERANT R 134A or SAFETY INSTRUCTIONS FOR HANDLING REFRIGERANT R134A !
Avoid contact with refrigerant and refrigerant oil
FOLLOW SAFETY INSTRUCTIONS FOR HANDLING REFRIGERANT OIL !
Refrigerant circuit is under high pressure!
Follow safety information for handling refrigerant. See INSTRUCTIONS FOR HANDLING REFRIGERANT R 134A or SAFETY INSTRUCTIONS FOR HANDLING REFRIGERANT R134A !
Avoid contact with refrigerant and refrigerant oil
FOLLOW SAFETY INSTRUCTIONS FOR HANDLING REFRIGERANT OIL !
IMPORTANT:
Risk of damage!
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit!
If air conditioning system is opened for more than 24 hours.
Replace DESICCANT INSERT for A/C system.
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit!
If air conditioning system is opened for more than 24 hours.
Replace DESICCANT INSERT for A/C system.
Necessary preliminary tasks:
- Remove left MODULE CARRIER .
- Draw off A/C SYSTEM .
Release screws (1).
Tightening torque 64 53 6AZ .
Pull air conditioning lines (2) of the air conditioning condenser.
Installation note:
Replace all sealing rings and moisten with refrigerant oil.
Lift out module carrier (1) right together with air conditioning condenser (2).
Release the air conditioning condenser from the module carrier. Release lock (1) on the side of the module carrier in direction of arrow.
Installation note:
When reinstalling the cooler and module carrier (1) the correct fit of the cooler in the bracket (2) must be ensured!
Reassemble the vehicle.