51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT INNER ENTRANCE COVER STRIP
Remove TRIM PANEL FOR PEDAL ASSEMBLY .

Release screw (1).

Remove hood/bonnet actuating lever (2) in direction of arrow from panel (3).

Fig 1: Removing Hood/Bonnet Actuating Lever From Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Detach mucket (2) in area of trim (5). See SEAL ON FRONT DOOR and NOTES ON SEALING INSTALLATION .

Release screw (1).

Unclip panel (5) in direction of arrow from retaining points (4).

If necessary, unlock plug connection of switch (3) and disconnect.

Remove trim (5).

Fig 2: Removing Panel From Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bores.

If necessary, replace faulty clips (1).

Preinstall clip (1) in trim (2).

Replacement:

Press catches and remove switch (3) in direction of arrow.

Fig 3: Removing Switch

Courtesy of BMW OF NORTH AMERICA, INC.