22 32 001 Replacing Rubber Mount For Transmission Mounting

WARNING: This page is about a different car, the 2010 BMW X6, 2009 BMW X6, and 2008 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

For the following special tools, refer to ENGINE AND GEARBOX SUSPENSION - SPECIAL TOOLS (N54, N63) .

22 1016
22 1 017
22 1 101
22 1 102
22 1 103

For the following special tools, refer to REAR AXLE - SPECIAL TOOLS .

33 4 465

Necessary preliminary tasks:

Remove crossmember for transmission mounting. See 22 32 050 REPLACING CROSSMEMBER FOR TRANSMISSION MOUNTING .

Place special tool 22 1 016 on opening (1) and insert screw (2) until hand-tight against housing.

Pull out rubber mount with special tools 22 1 101 /33 4 465 and nut (22 1 017 ).

Fig 1: Pulling Out Rubber Mount Using Special Tools 22 1 101, 33 4 465 And 22 1 017

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Arrow on rubber mount must point to arrow on housing.

Coat housing bore and rubber mount with Circolight (refer to BMW Parts Service).

Fig 2: Identifying Arrow On Rubber Mount And Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 22 1 102 with pins into openings of rubber mount.

Fig 3: Identifying Special Tool 22 1 102 On Openings Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Install rubber mount with special tools 22 1 102 /22 1 103 /33 4 465 and 22 1 017 .

Fig 4: Installing Rubber Mount Using Special Tools 22 1 102, 22 1 103, 33 4 465 And 22 1 017

Courtesy of BMW OF NORTH AMERICA, INC.