51 31 011 Replacing windscreen: Notes
IMPORTANT:
The "Instructions on cementing windscreen"
serve as the basis for this repair instruction and must be observed without fail.
Follow general procedure for dismantling/installation of affixed window glass.
Follow general procedure for dismantling/installation of affixed window glass.
NOTE:
Removal is performed with Roll Out 2000
.
Necessary preliminary work:
- Remove inside mirror
- Remove trim panels for roof pillar at front
- Remove cowl panel cover
- Remove gutter strips
- Remove windscreen rubber surround
Depending on version:
- Remove camera for lane departure warning
- Remove the solar rain/light/fogging sensor and immediately install on a new windscreen or a new sensor
Tape off body in area of piercing point with fabric adhesive tape.
Push wire from Roll Out 2000 along line (1) through adhesive bead (2).
For details on how to proceed, refer to: Window Removal with "Roll Out 2000" .
Lift out windscreen with suction cup.