65 50 170 Replacing the cover for the Central Information Display (CID) (as of 10/2009)

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION ).

Necessary preliminary work:

Release screws (1). Tightening torque 5.5 INCH lbs. (63 N.m). Note: To tighten screws, use special tool 00 9 460.

Fig 1: Release Screws (1)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage !

Carefully unlock latch mechanisms (1) with a suitable tool. Remove cover (2) from Central Information Display (3).

Fig 2: Carefully Unlock Latch Mechanisms (1) With A Suitable Tool

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Before/after assembly, cover is bolted to the Central Information Display, correct installation position must first be checked!

Installation note: Before connecting the screw connection, check whether latch mechanisms marked with an arrow are correctly seated.

Fig 3: Check Whether Latch Mechanisms Marked With An Arrow Are Correctly Seated

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: Before connecting the screw connection, check all-round rim at the places marked with an arrow.

Fig 4: Check All-Round Rim At The Places Marked With An Arrow

Courtesy of BMW OF NORTH AMERICA, INC.