12 61 285 Removing and installing/replacing oil level sensor for engine oil (N63, S63)

IMPORTANT: Read and comply with notes on protection against damage from electrostatic discharge (ESD protection).

Necessary preliminary tasks

Unlock connector (1) and remove.

Unscrew nuts (2).

Tightening torque 12 61 2AZ .

Remove oil level sensor (3).

Installation note:

Clean sealing surface on oil sump.

Replace seal on oil level sensor.

An excessively low torque value will result in oil leaks.

Fig 1: Identifying Oil Level Sensor, Connector And Mounting Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

An excessively high torque value will result in damage to the oil level sensor.

Top up engine oil.

Reassemble the vehicle.