63 12 015 Removing and installing or replacing left headlight (adaptive headlight)

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the power supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by specialist personnel.
Follow instructions for handling light bulbs (EXTERIOR LIGHTS) .

Necessary preliminary tasks

Remove FRONT WHEEL ARCH COVER FRONT SECTION .

Left headlight N62:

Release engine oil cooler

Release screw (1) on front side panel.

Release screw (2) on headlight.

Tightening torque 63 12 2AZ .

Disconnect plug connection (3).

Unclip wiring harness (4).

Fig 1: Identifying Plug Connection, Wiring Harness And Screws

G04792501

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Tape off front side panel in area (1).

Fig 2: Identifying Front Side Panel Taping Off Area

G08530722

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Carry out the following work step carefully in order to avoid damaging the side panel, headlight and wiring harness.

Release screws (1). Tightening torque 63 12 1AZ .

Press side panel (2) outwards slightly and feed out headlight towards rear.

Fig 3: Pressing Side Wall

G04792502

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

ADJUST headlight to body by way of knurled screws (1).
Adjust HEADLIGHTS .

Fig 4: Identifying Knurled Screws
Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove IGNITION UNIT/BULB FOR XENON HEADLIGHT .
Remove CONTROL UNIT FOR XENON HEADLIGHTS .
Remove DRIVE UNIT FOR ADAPTIVE HEADLIGHT .
If necessary, remove bulbs . See 63 99 076 REPLACING BULB FOR LEFT (OR RIGHT) XENON HEADLIGHT (WITH IGNITION UNIT) , 63 99 273 REPLACING BULB FOR FRONT LEFT (OR RIGHT) TURN INDICATOR or 63 99 145 REPLACING BULB FOR LEFT (OR RIGHT) SIDE LIGHTS (XENON HEADLIGHT) .