65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

Necessary preliminary tasks

NOTE: On RHD vehicles remove FRONT RIGHT WHEEL ARCH COVER .

Release screws (1) and remove cover (2).

Installation note:

Make sure rubber grommet (3) is correctly seated.

Fig 1: Identifying Rubber Grommet, Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove housing (2) and disconnect associated plug connection.

Fig 2: Identifying Housing And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Release nut (1) and remove emergency power siren with tilt alarm sensor (2).

Fig 3: Identifying Alarm Sensor And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Guides (1) of emergency power siren (2) must be correctly seated in area (3) of holder (4)!

Fig 4: Identifying Emergency Power Siren, Guides And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: