67 11 555 Removing and installing/replacing servodrive for tank filler flap

WARNING: This page is about a different car, the 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD
Remove DISTRIBUTION BOX

Feed out emergency release mechanism (1).

Slacken screws (2)

Feed out servodrive (3) in direction of arrow and disconnect associated plug connection.

Fig 1: Removing Servodrive With Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Turn sleeve (1) with a suitable tool (e.g.: pointed pliers) approx. 45° in direction of arrow and pull out of cover housing (2).

Fig 2: Turning Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide sleeve (1) over locking pin (2).

Make sure sleeve (1) is correctly engaged in cover housing (3).

Fig 3: Sliding Sleeve Over Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1).

Disengage emergency actuation pull strap (2) from retainer (5) and remove towards front.

If necessary, unclip locking pin (3) in direction of arrow from servodrive for tank filler flap (4).

Fig 4: Pulling Strap From Retainer

Courtesy of BMW OF NORTH AMERICA, INC.