54 37 140 Replace the roof module

Special tools required:

Necessary preliminary tasks:

Fig 1: Removing Roof Module

Courtesy of BMW OF NORTH AMERICA, INC.

Set removed roof module down on inside of lid of transportation crate and bolt down.

Switch special tool 54 0 101 to a new roof module.

Check the distances between the left and right consoles and left and right main bearing:

Measure the distance between guide pins.
Measure the distance between the rear threaded bolts.

Fig 2: Identifying Guide Pins Distances
Courtesy of BMW OF NORTH AMERICA, INC.

Check the measured lengths between the main bearings.

If applicable, adjust the distance that was measured between the guide pins with a twist sleeve (1).

If applicable, adjust the distance that was measured between the threaded bolts with a twist sleeve (2).

Fig 3: Identifying Rear Module Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Install the ROOF MODULE in the vehicle.

Detach removed roof module from inside of lid. Place the removed roof module in transport crate and screw down.

Remove special tool 54 0 101 .

Seal shipping crate.

Installation note:

Build date up to 07/2012:

Retrofit the wiring harness for the LEFT ROOF PACKAGE HALL EFFECT SENSOR .