52 13 002 Removing and installing the front seat on the passenger's side (normal/manual)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect BATTERY EARTH LEAD
Remove HEAD RESTRAINT

IMPORTANT: An airbag module and a pyrotechnical seat belt tensioner are installed in the front seat.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Installation note:

Powerlok screws must be replaced and must not be reused
Powerlok screws are mechanical screw locks with trilobular threads

Move backrest to full rearward position.

Grip end fitting cover in marked area between cushion and cover.

Unclip end fitting cover in direction of arrow (1).

Feed out end fitting cover (2) in direction of arrow.

Fig 1: Feeding Out End Fitting Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Install end fitting cover as follows:

Insert cover with front guide in cover
Insert cover in direction of arrow downwards in covering
Engage top cover in marked area in covering.

Fig 2: Installing End Fitting Cover
Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: 72 11 02AZ .

Remove end fitting.

Installation note:

End fitting is coded against incorrect assembly.

Fig 3: End Fitting Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Move seat to upper back position.

Release and dispose of screws (1).

Fig 4: Seat Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust the seat to the front top.

Release and dispose of screws (1).

Fig 5: Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

IMPORTANT: Cover door sill with protective covers (risk of damage).

Lift out front seat.

Fig 6: Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Carpet must not get between seat rails and floor panel in area of attachment points (squeaking noises)
Replace microencapsulated screws
Insert all screws loose to avoid twisting
Tighten down all screws to specified torque
Tightening torque: 52 10 01AZ .

WARNING: When carrying out further work on the front seat, it is absolutely imperative to observe the SAFETY REGULATIONS on handling airbag modules and pyrotechnical seat belt tensioners
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.