65 12 315 Removing and installing (replacing) HU-H) (version 1)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
There is a hard disk installed in the headunit.
Carry out mechanical work on the headunit and adjacent components with care.
Avoid subjecting the headunit to vibration/shocks.
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic damage (ESD protection).
NOTE:
Comply with notes and notes on HANDLING OPTICAL FIBRES
.
Necessary preliminary tasks:
- Remove RADIO AND IHKA CONTROLS
- Disconnect BATTERY EARTH LEAD
Removal:
Release screws (1).
Pull the HU-H (2) out forward.
Unlock and disconnect all connectors (1) in marked area.
Remove HU-H (2).
Installation:
Position HU-H (2).
Connect and lock all the connectors (1) in the marked area.
Slide the HU-H (2) toward the back into the instrument panel (3).
Tighten down screws (1).
NOTE:
Make sure the HU-H (2) is correctly seated on the retaining lugs at the marked points.
Required reworking:
- Install the RADIO AND IHKA CONTROLS
- Connect BATTERY EARTH LEAD
Only for US models with satellite radio:
When replacing the headunit, additional work is required!
- Refer to REPLACING SATELLITE TUNER, AS OF 09/2009 .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .
Load service history:
- 05 Maintenance and Pre-Delivery Check
- Service history