64 50... Leak detection with ultraviolet additives (UV additives) (BMW leak-testing case)
Observe national regulations in all other countries!
Read and comply with the manufacturers operating instructions provided with the special tool particularly with regard to accident prevention, health protection and environmental protection.
Use only BMW-approved UV additives (e.g. TRACER).
Only the basic procedure is described in the following!
Follow safety precautions when handling refrigerant . See 6450... NOTE FOR HANDLING R134A REFRIGERANT , 6450... SAFETY INFORMATIONS FOR HANDLING TETRAFLUORETHANE REFRIGERANT R134A or 6450... SAFETY INFORMATIONS FOR HANDLING REFRIGERANT OIL .
Do not use the ultraviolet lamp without the filter glass.
Eyes and skin will suffer damage if the ultraviolet lamp is used without the filter glass.
When using the ultraviolet lamp, wear the safety goggles provided in the case.
- Fill the hose system of the hand pump completely with UV additive PRIOR to use
- The UV additive may be used exclusively for BMW-approved refrigerant oils
- Do not operate the air conditioning system while the hand pump is connected or in use
- The air conditioning system must always be filled with an adequate amount of refrigerant to enable the leak-detecting agent to be properly distributed
Necessary preliminary tasks:
Before actually testing for leaks, check the entire refrigerant circuit using the UV leak detection lamp to ensure that no UV additive is already in the area of the refrigerant circuit.
Leak areas which have already been detected by UV light must carefully cleaned with the cleaning agent provided in the case.
On initial use:
Connect hand pump (1) to additive cartridge (2) and hose piece (3).
On initial use:
Attach vent valve (1) to quick-release coupling (2).
Turn handle (3) on hand pump to advance the piston until a small amount of UV additive emerges. This vents the hose system.
Attach quick-release coupling (1) to low-pressure connection (2) of air conditioning system.
Turn handle on hand pump (3) until the required amount of UV additive is added.
The quantity of UV additive to be added is dependent on the AMOUNT OF REFRIGERANT IN THE REFRIGERANT CIRCUIT :
- Air conditioning systems with refrigerant filling up to 900 g: one graduation mark (4) on additive cartridge
- Air conditioning systems with refrigerant filling in excess of 900 g: two graduation marks (4) on additive cartridge
Further tasks:
- Start engine
- Run air conditioning system at highest stage for 5 - 10 minutes in order to ensure adequate distribution of dye in the system
- Turn off engine.
- Check all air conditioning system components for possible leaks
- Possible leakage is lit up green when the UV leak-detecting lamp and UV-absorbing safety goggles are used
Complete accompanying information label (1) with the relevant data and attach in an easily visible position next to the filling capacity information label (2).