66 53 020 Removing and installing (replacing) reversing camera
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
Unclip rear view camera (1) left and right and feed out of button holders (2).
Unlock associated plug connection and disconnect.
Installation note:
Seal (3) of rear view camera (1) must not be damaged and must be installed.
Insert rear view camera (2) as shown in button holder (1).
Engage rear view camera (2) in direction of arrow in button holder (1).
Latch mechanisms (3) must not be damaged.
Installation note:
Make sure the rear view camera is latched correctly (2)!
After installation:
- Calibrate REVERSING CAMERA
Replacement:
Carry out VEHICLE PROGRAMMING/CODING .