51 24 147 Replace button for tailgate activation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 327

Attention!

Disassembly of the button is not possible without destroying it.

To avoid water ingress, the button must be replaced every time after disassembly.

Place special tool 00 9 327 at areas (A) between tailgate and button (1).

Destroy retaining tabs (2) in areas (A) by striking special tool 00 9 327 .

Pull out button (1) from latch mechanisms (2) in area (B).

Disconnect associated plug connections and remove button (1).

Installation note:

Check tailgate for damage, touch up if required.

Perform function check with tailgate open.

Fig 1: Placing Special Tool (00 9 327) Between Tailgate And Button

Courtesy of BMW OF NORTH AMERICA, INC.

Version with reversing camera:

Unclip rear view camera (1) left and right and feed out of button holders (2).

Installation note:

Gasket (3) of rear view camera (1) must not be missing or damaged.

Fig 2: Removing Rear View Camera

Courtesy of BMW OF NORTH AMERICA, INC.