51 13... Removing and installing/replacing partition wall attachment, right

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Turn locks (1) 90° counterclockwise.

Unlock catch (3).

Remove cover (2).

Fig 1: Partition Wall Attachment, Locks, Catch And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release clip (1).

Turn snap fastener (2) approx. 90° counterclockwise.

Disconnect plug connection (3) and feed out cable.

Release screws (6) and feed out attachment (5).

Replacement:

Twist sensor (4) approx. 90° anticlockwise and remove.

Fig 2: Partition Wall Attachment, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The following versions may be fitted:

Attachment (1) without air filter
Attachment (1) with air filter (2)
Attachment (1) with air filters (2 and 3)

Attachment (1) must only be fitted with air filter (2).

If necessary, remove air filter (3) and/or attach air filter (2) at position illustrated.

Fig 3: Air Filter Attachment

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Grille (1) on sealing frame (2) must be fitted.

If necessary attach new grille (1).

Grille (1) is pressed onto sealing frame (2) by air filter on attachment.

Grille (1) in conjunction with the air filter on the attachment prevents foreign objects entering.

Fig 4: Grille And Sealing Frame

Courtesy of BMW OF NORTH AMERICA, INC.