51 45... Removing and installing/replacing side panel on dashboard on left or right

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 327

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Pull off seal (1) in the area of the side panel (2).

Unclip side panel from dashboard (2) in direction of arrow with special tool 00 9 327 and feed out at a slant to the rear.

If necessary, unlock plug connection on switch for front passenger airbag deactivation and unplug.

Fig 1: Removing Side Panel From Dashboard With Special Tool (00 9 327)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) and guide tab (2) on side panel (3) must not be damaged or missing.

Fig 2: Side Panel Guide Tab And Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement with switch for front passenger airbag deactivation:

Saw out inside mark (1) with 25 mm dia. jigsaw.

Mill off remnants up to mark (1).

Fig 3: Front Passenger Airbag Deactivation Switch Mark

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remount SWITCH FOR FRONT PASSENGER AIRBAG DEACTIVATION .