61 14 005 Removing and installing/replacing distribution box (front)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

WARNING: Observe SAFETY INFORMATION for handling vehicle battery.

Necessary preliminary tasks:

Clamp off BATTERY LEAD FROM NEGATIVE CONNECTION POINT

NOTE: Work shown on the F20 by way of example, deviations in detail are possible in other models.

Turn locks (1) 90° counterclockwise.

Unlock catch (3).

Remove cover (2).

Fig 1: Identifying Locks, Catch And Cover

G10096920

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms (1) and remove lid (2).

Installation note:

Make sure lid (2) is correctly locked.

Fig 2: Identifying Latch Mechanisms And Lid

G10098319

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) and gasket (2) on lid (3) must not be damaged or missing.

Make sure gasket (2) is correctly seated in lid (3).

Fig 3: Identifying Latch Mechanisms, Gasket And Lid

G10098320

Courtesy of BMW OF NORTH AMERICA, INC.

Release power distribution box (1) with special tool 00 9 325 from lower section (2) and pull power distribution box (1) upward.

Fig 4: Releasing Power Distribution Box

G10098321

Courtesy of BMW OF NORTH AMERICA, INC.

Release and disconnect all plug connections in area (1).

Remove power distribution box (2).

Installation note:

Make sure all plug connections are correctly locked.

Fig 5: Identifying Power Distribution Box And Plug Connections

G10098322

Courtesy of BMW OF NORTH AMERICA, INC.