61 35 243 Removing and installing (replacing) Smart Opener top sensor line (non-contact rear lid opening)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Remove REAR BUMPER TRIM
NOTE:
Work shown on the F30 by way of example, deviations in detail are possible in other models.
Unlock associated plug connection (1) on control unit (2) and disconnect.
Installation note:
Make sure plug connection (1) and control unit (2) are correctly fitted.
Make sure connecting line is correctly laid.
IMPORTANT:
Risk of damage, do not kink sensor line!
Feed out associated connecting line in area A.
Release sensor line (1) at clips (2) and remove.
Installation note:
Make sure sensor line (1) is correctly fitted.
Make sure connecting line is correctly laid.
Clips (2) must not be missing or damaged.