41 61 014 Adjusting Engine Compartment Lid: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: These instructions apply only to vehicles without active pedestrian protection .
Observe separate procedure for vehicles with active pedestrian protection.

IMPORTANT: Do not damage adjoining body components.
Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.

Observe 41 00... BODY GAP DIMENSIONS .

NOTE: Stop screw must not be damaged or missing. If necessary, replace engine compartment lid hinge.

The stop screw is preset and must not be used to adjust the engine compartment lid.

Fig 1: Locating Stop Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nuts (1) of hinges on left and right.

Tightening torque 41 61 1AZ .

NOTE: If adjustment range is not sufficient, slacken screws on body and slide hinge. (Refer to "Height adjustment at hinge ")

Fig 2: Identifying Hinge Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust engine compartment lid sideways and lengthways.

Strikers must snap into place in engine compartment lid catch.

Fig 3: Adjusting Engine Compartment Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Height adjustment at hinge:

Slacken screws (1) and adjust engine compartment lid.

Tightening torque 41 61 2AZ .

Fig 4: Adjusting Height At Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Height adjustment at strikers:

Unclip the anti-twist lock (1).

Adjust height by turning the striker (2).

Height adjustment of engine compartment lid to side panel by means of stop pad. See ADJUSTING/REPLACING BUMP STOPS .

NOTE: The engine compartment lid is correctly adjusted in the front section by a combination of pulling the strikers and pressing the stop pads.
Incorrect adjustment results in either wobbling of the engine compartment lid or sluggish unlocking.

Fig 5: Adjusting Height At Strikers

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Check function of retaining hook.

After Installation note:

Tighten all screws and nuts to specified torque.
Touch up unpainted surfaces in the appropriate color.
If necessary, adjust front side panels.