64 11 841 Replacing actuator drive for right footwell flap

Necessary preliminary tasks: 

• Remove INSTRUMENT PANEL TRIM

Position of actuator drive: 

OVERVIEW OF ACTUATOR DRIVES ON HEATER/AIR CONDITIONER 

Release screws (1).

Take off holder (2).

Fig 1: Identifying Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip connector piece (1) and slide downwards.

Installation: 

Latching of connector piece (1) must be felt.

Fig 2: Disconnecting Connector Piece

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Feed out right footwell air outlet duct (2).

If necessary, disconnect plug connections at actuators.

Fig 3: Identifying Right Footwell Air Outlet Duct And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove servomotor (2) and unlock and disconnect plug connection (3).

Fig 4: Identifying Servomotor, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

• Body
• Heating and A/C function
• Flap motors
• Re-address flap motors