33 32 131 Replacing a wheel carrier
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove REAR WHEEL .
- Remove CAMBER ARM COVER .
- Remove COIL SPRING .
- Remove BRAKE DISC .
- Remove PARKING BRAKE SHOES .
- Remove PULSE SENSOR ON WHEEL CARRIER .
- Remove DRIVE FLANGE FOR REAR AXLE SHAFT .
Secure wheel carrier against falling out.
Slacken ANTI-ROLL BAR LINK ON WHEEL CARRIER .
Slacken TRAILING ARM ON WHEEL CARRIER .
Slacken CONTROL ARM ON WHEEL CARRIER .
Slacken TOE ARM ON WHEEL CARRIER .
Undo WISHBONE AT THE WHEEL CARRIER .
Slacken CAMBER ARM ON WHEEL CARRIER .
Remove wheel carrier including brake guard plate.
IMPORTANT:
- Prior to installation, check sensor head and cable of pulse sensor and renew if necessary.
- Replace WHEEL BEARING .
- Modify or replace BRAKE GUARD PLATE .
After installation:
- Adjust PARKING BRAKE .
- Carry out wheel alignment procedure . See 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 32 00 155 KDS WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .