51 11 050 Removing and installing/replacing carrier for front bumper trim: Notes

Necessary preliminary tasks:

Remove front BUMPER TRIM .
Remove fanfare horn on left and right. See REMOVING LEFT FANFARE HORN and REMOVING RIGHT FANFARE HORN .

Remove impact absorber (1) towards front.

Fig 1: Removing Impact Absorber

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2) on brake air duct (1).

Remove brake air duct (1) in direction of arrow.

Fig 2: Removing Brake Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

If ACC optional extra is installed:

Release screws (3) on ACC sensor bracket (1).

Tightening torque: 66 31 1AZ .

Unfasten plug connection (2) and disconnect.

Remove ACC sensor bracket (1).

Fig 3: Identifying ACC Sensor Bracket, Screws And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (2).

Tightening torque: 51 11 4AZ .

Unclip wiring harness (4) at marked points.

If necessary, unlock and disconnect plug connections (5) on short-range sensors.

Remove carrier (1) towards front.

Installation note:

Make sure locking sleeve (3) is correctly seated in carrier (1).

Fig 4: Identifying Wiring Harness, Plug Connections, Carrier, Locking Sleeve And Screws

Courtesy of BMW OF NORTH AMERICA, INC.