Condition for fault identification

Test condition:

The diagnostic fault code is logged when the difference between the specified and the actual value is greater than the characteristic curve over throttle-valve gradient (4% - 50%).

Potential problem source(s):

• Friction in throttle valve
• Defect in wiring harness between throttle-valve actuator motor and DME
• Defective throttle-valve actuator motor

Terminal condition: Terminal 15

Voltage condition:

• Onboard electrical system voltage between 9 V and 16 V

Temperature condition:

• None

Time condition:

• None

Other conditions:

• Active control signal to throttle valve