51 45 075 Removing and installing (replacing) support for instrument panel

Necessary preliminary tasks

Only if there is SA Head-Up Display

Fig 1: Identifying Steering Column And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) on A-pillar.

Tightening torque 51 45 2AZ .

Release screws (2) on tunnel.

Tightening torque 51 45 3AZ .

Release screws (1) on steering column support (2).

Tightening torque 51 45 1AZ .

Release screws (3) on steering column (4).

Tightening torque 32 31 1AZ .

Fig 2: Identifying Steering Column Support Plate Lowering Dimension

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on earth connection.

Release screw (2) on instrument panel trim holder (3).

Fig 3: Identifying Pedal Assembly, Carpet Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on instrument panel trim holder (2).

Remove instrument panel carrier and if necessary feed out through front passenger door.

Fig 4: Identifying Pedal Assembly, Carpet Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Only slacken screws (2) on steering column (1) near universal rubber joint.

Tightening torque 32 31 1AZ .

Fig 5: Removing Instrument Panel Cover Using Special Tool (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Lower steering column support plate (2) by continuing to turn screws to measurement x underneath attachment points (1).

Measurement x = 25 mm

WARNING: Do not unscrew screws too far; if steering column falls, this will damage the universal rubber joint.

Remove support with assistance from second person.

Fig 6: Identifying Cover And Retaining Tabs

Courtesy of BMW OF NORTH AMERICA, INC.