62 30 010 Removing and installing/renewing head-up display

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION ).

IMPORTANT: Comply with notes and notes on HANDLING OPTICAL FIBRES .
Risk of damage!
Do not scratch lens of head up display.

Necessary preliminary work

Release screw (1) on carrier housing (2) at bottom.

Tightening torque 62 30 1AZ .

Fig 1: Identifying Carrier Housing And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove sound insulation (1) from head-up display (4).

Disconnect plug connections (2).

Release screws (3).

Tightening torque 62 30 1AZ .

Carefully feed out head-up display (4) in upward direction.

Installation note:

Clean lens of head-up display.

Fig 2: Identifying Plug Connections, Head-Up Display, Insulation And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: