51 11 770 Removing and installing/replacing left or right deformation element for front bumper
Necessary preliminary tasks
- Disconnect BATTERY NEGATIVE TERMINAL
- Remove CARRIER for bumper trim at front
- Remove HEADLIGHT
Release screws (1).
Tightening torque 51 11 2AZ .
Remove expander rivets (1).
Remove and replace expander rivets (2).
Slacken nut (1).
Tightening torque 51 11 3AZ .
Drill out rivets (2) and do not replace any more.
Remove deformation element (3) towards front.
IMPORTANT:
After assembly: Adjust headlight.