63 17 070 Removing and installing/replacing left front fog lamp

Necessary preliminary tasks:

Disconnect plug connection (1).

Release screws (4) and remove fog lamp (2) from bumper trim (3). Tightening torque 63 17 1AZ .

Installation:

Make sure fog lamp (2) is correctly seated on bumper trim (3).

Guide (5) of fog lamp (2) must be positioned in associated recess in bumper trim (3).

Fig 1: Identifying Plug Connection, Screws, Fog Lamp And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove BULB .