51 71 280 Removing and installing/replacing units compartment partition wall
Necessary preliminary tasks:
Units compartment partition wall, middle:
Remove gasket (1) for engine compartment lid.
Release screws (2, 4).
Remove partition wall (3).
Installation note:
Make sure partition wall is correctly positioned.
Only for version with N55, N57, M57 engine (version up to 10/2012):
SEAL THE UNITS COMPARTMENT PARTITION WALL AT THE TOP CENTER .
Units compartment partition wall, left:
Release expansion rivet (1).
Release screws (2, 4).
Left only: Unclip connecting line (3).
Remove partition wall (5).
Installation note:
Replace damaged expanding rivet.
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.
Units compartment partition wall, right:
Release clip (1).
Unfasten screws (2).
Remove partition wall (3).
Installation note:
Replace faulty clip (1) if required.
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.