61 14 010 Removing and installing/replacing power distributor (on battery)

WARNING: Observe SAFETY INSTRUCTIONS for handling vehicle battery.

Necessary preliminary tasks:

Fig 1: Identifying Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

If necessary, release wiring harness fasteners from power distributor.

Open covers (2) and release nuts underneath.

Tightening torque:

Fig 2: Identifying Plug Connection And Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Press locking brackets (2) downwards and unclip.

If necessary, using a screwdriver (1), expand locking bracket (2) at lower end and clip out.

Remove power distributor (3) towards top.

Fig 3: Removing Power Distributor Towards Top

Courtesy of BMW OF NORTH AMERICA, INC.