51 37 000 Removing and installing / replacing complete rear left or right power window regulator
WARNING:
Danger of injury!
Carry out work on the power window regulator only when the power window motor is de-energized.
Carry out work on the power window regulator only when the power window motor is de-energized.
Necessary preliminary tasks:
- Remove rear side window glass. See REPLACING REAR SIDE WINDOW GLASS (WITHOUT ROLLER SUN BLIND) or REPLACING REAR SIDE WINDOW GLASS (WITH ROLLER SUN BLIND) .
Slacken bolt (1).
Tightening torque 51 35 11AZ .
Release screws (4).
Tightening torque 51 35 2AZ .
Disconnect plug connection (5).
Feed out power window regulator (3).
Installation note:
Holder (2) must be correctly seated on inner door panel rail.
Installation note:
Make sure guide lug (2) of power windows (1) is correctly seated in recess of door structure.
Concluding tasks
Replacement:
Swap over FLAT MOTOR FOR POWER WINDOW REGULATOR .