Condition for fault identification

Test condition:

The fault is recognized when the indicated sensor value on Bank 1 deviates by (-330 mbar or 10 %) during the post-operational shutdown phase.

Potential problem source(s):

• Defect in wiring harness
• Fault in intake-manifold pressure sensor

  Terminal condition: none

  Voltage condition:

• Electrical system voltage > 10 V

  Temperature condition:

• 10 °C < control module temperature < 150 °C
• 10°C < intake-air temperature < 90°C

  Time condition:

• 5 seconds after engine stops during post-operational shutdown phase

  Other conditions:

• none