72 11 070 Removing and installing/replacing front lower belt fitting (belt tensioner), driver's seat

Necessary preliminary tasks 

• Remove front seat, driver's side. See 52 14 001 REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE .

Installation: 

• Microencapsulated screws (Loctite) must be replaced and may not  be reused
• Screw connection must be completed within 20 minutes (start of curing)
• Microencapsulated screws must not  be retightened
• Clean thread of nut beforehand in event of repeated use

UNLOCK AND DISCONNECT  plug connections (1).

Release screw (1).

Installation: 

Replace screw (1).

Tightening torque 72 11 03AZ .

Remove seat belt tensioner.

Installation: 

Belt tensioner is coded against incorrect installation.