LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2012 >> 528i >> Repair and Diagnosis >> Electrical >> Gauges >> Body Equipment - Repair >> Front Bumper >> 51 11 156 Removing and installing (replacing) front bumper panel

51 11 156 Removing and installing (replacing) front bumper panel

IMPORTANT: Before making repairs on the bumper panels with the "active pedestrian protection", the associated NOTES must be observed.

Necessary preliminary tasks: 

Not for M5: 

Release expanding rivet (1) from left and right air ducts (2).

Fig 1: Identifying Air Ducts Rivets
G09925710Courtesy of BMW OF NORTH AMERICA, INC.

Remove sealing (1).

Fig 2: Identifying Air Ducts Sealing
G09925711Courtesy of BMW OF NORTH AMERICA, INC.

Release expanding rivet (2) of side cover (1) on left and right.

Raise side cover (1) for each of the next operations.

Fig 3: Identifying Rivet And Side Cover
G09925712Courtesy of BMW OF NORTH AMERICA, INC.

Release all screws at top and bottom on bumper panel (1).

Fig 4: Locating Bumper Panel Screws
G09925713Courtesy of BMW OF NORTH AMERICA, INC.

Version with night vision: 

Release retaining screw (1).

Fig 5: Identifying Bumper Retaining Screw
G09925714Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: The wheel was removed for clarity.

Change steering angle to suit current the current job item.

Release bolt (1) on wheel arch panel. Tilt wheel arch panel sideways.

Release left and right screws (2) behind.

Tightening torque 51 11 11AZ .

IMPORTANT: Bumper panel must not be pulled out sideways (risk of damage).
Fig 6: Identifying Wheel Arch Panel Bolt And Screw
G09925715Courtesy of BMW OF NORTH AMERICA, INC.

For version with Side View camera: 

Unlock plug connection (3) on left and right and disconnect.

Fig 7: Identifying Bumper Plug Connection
G09925716Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Bumper panel must not be pulled out sideways (risk of damage).

Disconnect the right wiring harness connector and if necessary the additional plug-in contacts and feed out cable.

Version with night vision: 

Release plug connection (2) and high-pressure nozzle line (3) on night vision camera (1) and disconnect.

Remove bumper panel straight towards front with aid of a 2nd person.

Installation note: 

Observe 41 00... BODY GAP DIMENSIONS .

Fig 8: Identifying Plug Connection, High Pressure Nozzle Line And Vision Camera
G09925717Courtesy of BMW OF NORTH AMERICA, INC.

Replacement (depending on version):