61 35 015 Removing and installing (replacing) control unit for Car Access System
IMPORTANT:
Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .
NOTE:
The comfort access system is a radio-based system and can be interfered with by radio waves from other systems (e.g. mobile phone).
Necessary preliminary tasks
- Remove TRIM FOR PEDAL MECHANISM
Disconnect plug connection (2).
IMPORTANT:
Carefully disconnect ribbon cable plug connection (1).
Replace the ribbon cable if damaged.
The ribbon cable leads to:
Replace the ribbon cable if damaged.
The ribbon cable leads to:
Release screw (3).
Feed out control unit for Car Access System (4) to the left and remove towards bottom.
Installation note:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mount.
Replacement:
- Carry out VEHICLE PROGRAMMING/ENCODING
- Version with auxiliary heater:
Initialize Telestart hand-held transmitter . See 64 12... INITIALIZING TELESTART HAND TRANSMITTER (T90) (UP TO BUILD DATE 03/2007) or 64 12... INITIALIZING TELESTART HAND-HELD TRANSMITTER (T93) (FROM VERSION 03/2007 ONWARD) .