64 12... Initializing Telestart hand-held transmitter (T93) (from version 03/2007 onward)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 335is, 2013 BMW 335i, 2012 BMW 335is, 2012 BMW 335i, and 2011 BMW 335is. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Telestart hand-held transmitter must be initialized after:
The auxiliary heating is switched on under an ambient temperature of approx. 15 °C with the hand-held transmitter and at a preselected switch-on time.
Direct activation is possible at any outside temperature via the "Climate" menu item in the i-Drive, but not in driving mode.
- Hand-held transmitter is replaced
- Car Access System control unit is replaced
The auxiliary heating is switched on under an ambient temperature of approx. 15 °C with the hand-held transmitter and at a preselected switch-on time.
Direct activation is possible at any outside temperature via the "Climate" menu item in the i-Drive, but not in driving mode.
| Item | Explanation |
|---|---|
| 1 | ON button |
| 2 | OFF button |
| 3 | Indicator light |
Procedure of initialization
- Close all vehicle doors
- Insert radio-operated key into shaft and immediately remove again, switch d.h. terminal R on and off (max. switched-on period 5 s)
- Within 10 s, simultaneously press the ON button and the OFF button for 3 s.
The indicator light (LED) lights up orange.
- Release both buttons.
- Within 10 s (while the indicator light is lit) operate the ON button briefly three times.
The indicator light flashes orange (approx. 1.5 s long).
- The central locking signals successful initialization of the Telestart transmitter by immediately locking and unlocking.