51 16 200 Removing And Installing Storage Compartment

Necessary preliminary tasks

Lever out covers (1) and release screws underneath.

If necessary, detach cable from storage compartment.

Fig 1: Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Depending on equipment specification, disconnect plug connections (2).

Installation:

Ensure correct cable routing.

Fig 2: Plug Connections And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off gaiter (1) towards top.

Detach plug connection (2) from holder and disconnect plug connection (2).

Fig 3: Disconnecting Plug Connection From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Raise storage compartment (2) at rear and feed out gaiter (1) through opening.

If necessary, disconnect further plug connections and feed out cable.

Remove storage compartment (2) towards rear/top.

Fig 4: Removing Storage Compartment Towards Rear/Top

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guide (1) of storage compartment (2) must be fed behind panel (4) on left/right.

Version with ventilated multifunction storage:

Air duct (3) must be correctly inserted in storage compartment (2).

Fig 5: Air Duct And Storage Compartment

Courtesy of BMW OF NORTH AMERICA, INC.