Condition for fault identification

Test condition:

The fault is recognized when the oil condition sensor reports a fault over the bus.

Potential problem source(s):

• Defect in plugs or wiring harness between oil condition sensor and DME
• Water in oil
• Oil condition sensor defective

Terminal condition: Terminal 15

Voltage condition:

• Onboard electrical system voltage between 9 V and 16 V

Temperature condition:

• Engine oil temperature greater than 100 °C

Time condition:

• Longer than 15 minutes

Other conditions:

• Engine on
• Engine speed above 5000 RPM
• No BSD fault