26 12 011 Replacing grooved ball bearing in center mount of propeller shaft

Necessary preliminary tasks 

• Replace PROPELLER SHAFT CENTRE MOUNT 

Press grooved ball bearing using special tool 23 1 160 out of center mount (1).

Fig 1: Pressing Grooved Ball Bearing Using Special Tool (23 1 160)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat rubber-coated bearing seat of center mount (2) with Circolight.

Using special tools 33 3 202/33 3 203, press new grooved ball bearing (1) into center mount (2).

Fig 2: Pressing Deep Groove Ball Bearing Into Centre Mount Using Special Tools (33 3 202) And (33 3 203)

Courtesy of BMW OF NORTH AMERICA, INC.