26 12 001 Replacing complete propeller shaft center mount

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Remove PROPELLER SHAFT .

NOTE: The propeller shaft is balanced. The front and rear propeller shafts must be reassembled in the same position.

Detach gaiter (1) from groove (2).

Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.

Installation:

Make sure gaiter (1) is securely seated in groove (2).

Fig 1: Identifying Front And Rear Propeller Shaft Marks

Courtesy of BMW OF NORTH AMERICA, INC.

Pull propeller shaft apart.

Fig 2: Pulling Propeller Shaft Apart

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, insert new clamping ring (1) into front propeller shaft (2).

Fig 3: Identifying Front Propeller Shaft With Clamping Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.

Installation:

Apply a coating of grease to longitudinal splines on shaft. See PROPELLER SHAFT - OPERATING FLUIDS

Push gaiter (1) during installation into groove (2) and make sure it is firmly seated.

Observe markings and force front propeller shaft onto longitudinal splines (markings must be flush).

Fig 4: Identifying Gaiter And Groove

Courtesy of BMW OF NORTH AMERICA, INC.

Install special tool 00 7 500 between center mount (1) and universal joint (2).

Fig 5: Installing Special Tool (00 7 500) Between Centre Mount And Universal Joint

Courtesy of BMW OF NORTH AMERICA, INC.

Using a hydraulic press, force center mount (1) off propeller shaft (2).

Fig 6: Forcing Centre Mount Of Propeller Shaft Using Hydraulic Press

Courtesy of BMW OF NORTH AMERICA, INC.

Force new center mount (1) onto propeller shaft. Collar (2) must point in direction of travel towards front propeller shaft. Drive center mount firmly home with special tool 23 1 160.

Fig 7: Forcing Centre Mount Firmly Home Using Special Tool (23 1 160)

Courtesy of BMW OF NORTH AMERICA, INC.