24 14 002 Replacing shaft seal for selector shaft (GA6HP19Z)

WARNING: This page is about a different variant/trim than selected.

Special tools required

IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL .
Use only the approved AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks

Remove heat shields

Brace clamping bush (1) and loosen nut (2).

Detach retainer (3) downwards using a screwdriver.

Pull cable (4) out of holder.

Installation:

ADJUST SELECTOR LEVER .

Fig 1: Identifying Clamping Sleeve, Nut And Retainer

G04726075

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Take off holder (2).

Tightening torque 24 51 1AZ .

Fig 2: Identifying Holder With Nut

G04726123

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 5 361 until it is firmly connected with radial shaft seal hat.

Fig 3: Identifying Radial Shaft Seal With Special Tool (24 5 361)

G04726125

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 24 5 362 onto special tool 24 5 361 and tighten down.

This pulls the shaft seal out of the transmission housing.

Fig 4: Identifying Special Tool (24 5 362) And (24 5 361)

G04726126

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal (1).

Screw in radial shaft seal (1) with special tools 24 5 366 and 24 5 364 as far as it will go.

Fig 5: Installing Radial Shaft Seal Using Special Tool (24 2 351) And (24 2 352)

G04726130

Courtesy of BMW OF NORTH AMERICA, INC.